Why RS1 care starts with the connector
Before you worry about pads or polishing, the most important care decision for your Grado RS1 happens at the cable. The RS1 is offered with a choice of connector options: a Standard connector or a cable terminated with XLR. The XLR termination option adds $170.00. Choosing the right one for your equipment prevents unnecessary adapters and strain on the cable, which is the first step in long-term maintenance.
Connector options for the RS1
A simple routine for keeping the RS1 in shape
These habits focus on the parts you touch most: the pads, the cable, and the headband. They are general best practices for open-back headphones, not manufacturer instructions.
- Wipe the pads after each session: Use a dry, soft cloth to remove skin oils and sweat. Avoid soaking the pads or using harsh cleaners, which can break down foam over time.
- Check the cable at the connector: Inspect the plug and the strain relief for kinks or fraying. If you chose the XLR option, make sure the connector is fully seated and not bearing the weight of the cable.
- Store open-back headphones safely: Keep the RS1 on a stand or in a case when not in use. Open-back designs have exposed grilles, so dust and debris can enter the driver housing if left out.
- Keep the headband clean: Wipe the headband with a dry cloth. Avoid stretching it unnecessarily when putting the headphones on or taking them off.
Cleaning the pads without damaging them
The RS1 uses foam pads that can degrade with repeated exposure to moisture and oils. A gentle wipe with a dry microfiber cloth after each use is usually enough. If the pads become visibly soiled, a slightly damp cloth with plain water can be used, but let them air-dry completely before putting the headphones back on. Never use alcohol or abrasive cleaners, as they can dry out the foam. When the pads start flaking or losing their shape, replacement is the best care step.
Cable care for the Standard and XLR options
The RS1 cable is not detachable, so protecting it matters. Avoid wrapping it tightly around the headphones or pulling it by the cable to unplug. When disconnecting, grip the plug body, not the wire. For the XLR version, the larger connector puts more weight on the jack, so support it when possible. Coil the cable loosely in a figure-eight when storing to prevent memory kinks.
When to consider a different connector
If you find yourself constantly using an adapter, or if the cable is under strain because the plug doesn't match your equipment, it may be worth choosing the other termination option at purchase. The RS1 is available with either a Standard connector or an XLR termination, and the XLR option adds $170.00. This is a decision to make before you buy, since the cable is fixed.


