Back to Blog
How-to Guides 2026-11-17 Grado Labs 0 views

Grado Plastic End Caps: Fit, Replacement, and Installation

Grado Plastic End Caps: Fit, Replacement, and Installation

Learn where Grado plastic end caps fit on your headphones, when to replace them, and a safe installation approach using the genuine set of two.

What these end caps are and where they go

Grado Plastic End Caps are genuine replacement parts sold as a set of two. They are intended for use with Grado headphones and are listed under accessories and replacement parts. The supplied information confirms they fit all Grado headphones, but it does not specify which exact locations on each model they attach to. Before ordering, check your headphone's parts diagram or contact Grado support to confirm the end caps are the correct component for your repair.

Confirmed product details

  • Plastic End Caps (set of two): Grado Plastic End Caps are genuine replacement parts sold as a set of two. Knowing you receive a pair means you can replace both sides at once if needed, and genuine parts help maintain original fit.
    Plastic End Caps (set of two)
    Plastic End Caps (set of two)
  • Plastic End Caps (set of two): They are intended for use with Grado headphones and fit all Grado headphones. This broad compatibility suggests they are a common wear item across the Grado range, but you should still verify the specific location on your model.

How to install replacement end caps

The supplied information does not include a step-by-step procedure, so the following is a general approach based on common sense for small plastic parts. Proceed carefully and stop if anything feels forced.

  1. Identify the old end caps: Locate the plastic end caps on your headphones. They are likely at the ends of a rod or housing, but confirm with your model's diagram if unsure.
  2. Remove the old caps: If the old caps are damaged or loose, gently remove them. Avoid pulling on wires or forcing any connected parts.
  3. Test-fit the new caps: Before pressing fully into place, check that the new end caps align with the mounting points. They should seat without excessive force.
  4. Seat the new caps: Press the end caps into position evenly. If they do not seat easily, recheck orientation and alignment rather than forcing them.

When replacement is the right move

Replace your end caps if they are cracked, missing, or no longer hold securely. Because these are genuine Grado parts sold as a pair, replacing both at the same time helps keep the look and fit consistent. If your headphones are still under warranty, check with Grado before attempting any repair yourself.

What the supplied information does not cover

The catalog record does not specify which headphone models use these caps at which locations, nor does it include installation instructions or care guidelines. For model-specific guidance, refer to Grado's documentation or support. This article gives a general installation approach, but always prioritize any official instructions that come with your headphones.

Related Articles

Customer Service
Home
Products
Cart
Profile